ASCII - Command | MOVE | |||
Syntax Transmit | MOVE [Data] | |||
Syntax Receive | MOVE <Data> | Available in | ||
Type | Command | MMI | Yes | |
ASCII Format | Integer16 | CANBus Object Number | 3642 (hex) | |
DIM | - | PROFIBUS PNU | 1922 (dec) IND = 1 (dec) | |
Range | 0 ... 300 | DPR | 322 (dec) | |
Default | 0 | |||
Opmode | 4, 8 | Data Type Bus/DPR | Integer16 | |
Drive State | Enabled | Weighting | ||
Start Firmware | 1.0 | |||
Configuration | No | Last Change of this Object | 2.12 | |
Function Group | control commands | EEPROM | No | |
Short Description | Start Motion Task |
Description
The command “MOVE nr” starts the motion task “nr” from the motion task memory. If the command is used without a parameter, then the number of the most recently started task will be displayed. |