| ASCII - Command | CONTINUE | |||
| Syntax Transmit | CONTINUE | |||
| Syntax Receive | CONTINUE | Available in | ||
| Type | Command | MMI | No | |
| ASCII Format | Command | CANBus Object Number | 351D (hex) | |
| DIM | - | PROFIBUS PNU | 1629 (dec) IND = 1 (dec) | |
| Range | - | DPR | 29 (dec) | |
| Default | - | |||
| Opmode | 8 | Data Type Bus/DPR | - | |
| Drive State | Enabled | Weighting | ||
| Start Firmware | 1.0 | |||
| Configuration | No | Last Change of this Object | 1.0 | |
| Function Group | control commands | EEPROM | No | |
| Short Description | Continue last position order | |||
Description
| The CONTINUE command can be used to continue (and complete) a motion block that was previously interrupted by the STOP command. This is especially important for a motion block with relative paths. |