| ASCII - Kommando | BISSCNFG | |||
| Syntax Senden | BISSCNFG [Data] | |||
| Syntax Empfangen | BISSCNFG <Data> | Vorhanden in | ||
| Type | Variable rw | Setup Software | Nein | |
| ASCII Format | Integer16 | CANBus Objektnummer | 38B7 (hex) | |
| DIM | - | PROFIBUS PNU | 1751 (dec) IND = 33 (dec) | |
| Bereich | -32768 .. 32767 | DPR | 951 (dec) | |
| Default | 0 | |||
| Opmode | All | Datentyp Bus/DPR | Integer16 | |
| Verstärker Status | Disabled + Reset (Coldstart) | Wichtung | ||
| ab Firmware | 5.06 | |||
| Konfiguration | Ja | Letzte Bearbeitung der Seite REV | 2.14 | |
| Funktionsgruppe | feedback | EEPROM | Ja | |
| Kurzbeschreibung | Konfigurationsparameter für BiSS-C | |||
Beschreibung
| Dieser Parameter wird in Verbindung mit dem FBTYPE = 33 genutzt. Er setzt zum einen fest, wie viele Bits für die Position eines BiSS C-Mode unidirektional Gebers abgeholt werden müssen, also die Auflösung und zum anderen welchen Aktiv – Pegel das Error- und Warn – Bit im Frame haben. Nach BiSS Spezifikation sind das Error und das Warn Bit aktiv ‚0’. Sollte eine Invertierung erforderlich sein, ist dies durch folgende Addition möglich. Error – Bit 0x1000 (4096) active ‚1’ Warn – Bit 0x2000 (8192) active ‚1’ |