| ASCII - Command | MOVE | |||
| Syntax Transmit | MOVE [Data] | |||
| Syntax Receive | MOVE <Data> | Available in | ||
| Type | Command | MMI | Yes | |
| ASCII Format | Integer16 | CANBus Object Number | 3642 (hex) | |
| DIM | - | PROFIBUS PNU | 1922 (dec) IND = 1 (dec) | |
| Range | 0,1,..,180,192 .. 255 | DPR | 322 (dec) | |
| Default | - | |||
| Opmode | 8 | Data Type Bus/DPR | Integer16 | |
| Drive State | Enabled | Weighting | ||
| Start Firmware | 1.20 | |||
| Configuration | No | Last Change of this Object | 1.3 | |
| Function Group | Position Controller | EEPROM | - | |
| Short Description | Start Motion Task | |||
Description
| The command “MOVE nr” starts the motion task “nr” from the motion task memory. If the command is used without a parameter, then the number of the most recently started task will be displayed. |