toolbox
Seite ausdrucken

---------------------

---------------------

.Menuesprache DE / EN
Seitensprache
Menü [verbergen]






AKMH Motor

Table of Contents

Application area for these motors is the food and beverage industry, without direct contact with unpacked foodstuffs, according to EN 1672-5.3.2.

Applications can be cutting, packing and filling without direct contact with foodstuffs. The motor should be placed laterally or below the food.

Due to protection class requirements for hygienic applications it is not possible to offer a connector solution for  motors. The motors must be ordered with fixed cables and a defined cable length.

The motors can be mounted to the linear actuators ERD.

Hygienic features

  • Smooth surface (roughness <0,8μm)
  • No ups and downs , in which organic matter can remain
  • Gap-free
  • Easy to clean and disinfect
  • Projections, edges or recesses are reduced to a minimum
  • Curves with a radius of > 3mm
  • Laser printed

Literature / Drawings

Technical Data

Technical data of all available motor windings can be found in the motor manual .
Technical data of the built-in holding brakes are on page Holding Brake.

Connectivity

The motors are available with either one or two fixed cables. The one cable solution supports digital feedback system SFD, SFD3 and HIPERFACE DSL. The two cable solution is necessary for support of Resolver and Comcoder feedbacks.

Resistancy against cleaners

AKMH surface is resistant against industrial cleaners.

Standards:  UL, CE, RohS,
according to DIN EN ISO 14159 and DIN EN 1672-2
 
Surface: 

Stainless steel 1.4404, roughness less than 0.8µm

 
Resistancy:  Against tested cleaning agents, corrosion resistant Test Report
Protection class:   IP69K  
Screws:

Stainless steel 1.4404, Silicone seal FDA 21 CFR 175.300

FDA Material List
O-Ring: EPDM, FDA 21 CFR 177.2600
Shaft:  Stainless steel 1.4404
Shaft seal: 

Mineral filled PTFE, single lip,
mineral: FDA 21 CFR 175.300
PTFE: FDA 21 CFR 177.1500

Lubricant:  food-grade as per  FDA 21 CFR 178.3570
Cable gland:  Stainless steel 1.4404, Silicone seal FDA 21 CFR 177.2600
Cable tube:  Silicone FDA 21 CFR 177.2600
Name plate:

Laser marked in housing

 
Size:  AKMH2 - AKMH6   

Approvals

CE ULUSDA, FDA NSF BISSC

Application Notes

Further Information

mediacode 302aaae