ASCII - Command | WMASK | |||
Syntax Transmit | WMASK [Data] | |||
Syntax Receive | WMASK <Data> | Available in | ||
Type | Variable rw | MMI | Yes | |
ASCII Format | Integer32 | CANBus Object Number | 363E (hex) | |
DIM | - | PROFIBUS PNU | 1918 (dec) IND = 1 (dec) | |
Range | 0 .. 4294967295 (1 Bit is 1 warning) | DPR | 318 (dec) | |
Default | 0 | |||
Opmode | All | Data Type Bus/DPR | Integer32 | |
Drive State | - | Weighting | ||
Start Firmware | 2.49 | |||
Configuration | No | Last Change of this Object | 1.7 | |
Function Group | Amplifier | EEPROM | No | |
Short Description | Warning as Fault Mask |
Description
The WMASK parameter can be used to reconfigure a warning to the fault message F24. WMASK is a bit-variable, with bit assignments that correspond to the STATCODE * status variable. The bit that is set within the WMASK variable means that the corresponding warning bit in the STATCODE * variable should generate an F24 fault message, as well as a warning. Unlike warnings, a fault message results in the disabling of the output stage, and the opening of the RTO contact. A reconfiguration can be especially relevant for changing a following error n03 (this is normally indicated as a warning ) to a fault. The value has to be entered in decimal. See also LASTWMASK |