Screen page "Drive status"
Run time
|
ASCII: TRUN |
Default: - |
valid for all OPMODES |
Display of the operational time of the servo amplifier, saved at 8 minute
intervals. If the 24V-supply is switched off, maximum 8 minutes of operation
are unregistered.
Last 10 faults
|
ASCII: FLTHIST |
Default: - |
valid for all OPMODES |
The last 10 faults that occurred are displayed, together with the time
of their occurrence, referred to the operating hours.
Rate of occurrence
|
ASCII: FLTCNT |
Default: - |
valid for all OPMODES |
Display of the frequency of all faults that caused the servo amplifier
to switch off.
Actual errors
|
ASCII: ERRCODE |
Default: - |
valid for all OPMODES |
Display of the errors presently being reported by the servo amplifier (corresponds
to the error messages Fxx in the LED-display on the front panel of the
amplifier)
Actual warnings
|
ASCII: STATCODE |
Default: - |
valid for all OPMODES |
Display of the warnings presently being reported by the servo amplifier (corresponds
to the
warnings nxx in the LED-display on the front panel of the amplifier)
Reset
|
ASCII: CLRFAULT |
Default: - |
valid for all OPMODES |
Software-reset of the servo amplifier. The servo amplifier must be disabled.
Present
errors are deleted, the firmware is re-initialized, and communication is
re-established.
If only errors marked with an asterisk in the error listing are present,
then the errors are canceled, but no reset of the amplifier takes place.